Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Fuel Pump and Filter Removal (In-Tank)

General Motors — Fuel Pump and Filter Removal (In-Tank)

A General Motors service procedure — check it applies to your exact model before use.

Browse General Motors generators & specs →

Procedure

  1. Drain the fuel tank, refer to Fuel Tank Draining Procedure.
  2. Remove the multivalve assembly from the tank refer to Multivalve Removal.
  3. Reach into the tank and disconnect the Fuel Pump electrical connector.
  4. Release the top spring retaining the Fuel Pump and holder.
  5. Release the two lower retaining springs.
  6. Lift the plastic pump and holder from the tank.
  7. Slide the Fuel Pump from the filter.

Source: manual:FuelSystem.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.