Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›installer. Install flywheel, clutch (M/T) and transmission.

General Motors — installer. Install flywheel, clutch (M/T) and transmission.

A General Motors service procedure — check it applies to your exact model before use.

Browse General Motors generators & specs →

Before you start

  • Removal (Except "S" & "T" Series Pickup, Jimmy & Sonoma)
  • crankshaft pulley or any sheet metal when lifting engine.
  • Minimal clearance exists between oil pump pick-up tube
  • and bottom of oil pan. DO NOT place jack under oil pan,

Procedure

  1. Disconnect battery. Raise and support vehicle. Drain crankcase. Remove exhaust
  2. Remove starter. Remove or disconnect engine oil cooler lines and/or transmission fluid
  3. Disconnect battery. Remove engine oil dipstick and accessory drive belt splash shield.
  4. Remove second crossmember. Remove converter hanger bolts and exhaust pipe clamp

Source: manual:1995 ENGINE 4.3L VIN W_text.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.