Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Remove transmission, clutch (M/T) and flywheel. Pry seal from housing.

General Motors — Remove transmission, clutch (M/T) and flywheel. Pry seal from housing.

A General Motors service procedure — check it applies to your exact model before use.

Browse General Motors generators & specs →

Procedure

  1. Lubricate inner and outer diameter of seal with engine oil. Place seal on Seal Installer
  2. Thread attaching screws into crankshaft flange and tighten with screwdriver. This

Source: manual:1995 ENGINE 4.3L VIN W_text.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.