Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Starting Pull Start Engines

Generac XD5000E — Starting Pull Start Engines

Operation

For the Generac XD5000E, from the Generac owner's manual.

Applies to: Generac XD5000E

Before you start

  • Recoil Hazard: recoil could retract unexpectedly, causing death or serious injury.
  • Disconnect electrical loads prior to starting or stopping unit.

Procedure

  1. Unplug all electrical loads from the unit's receptacles before starting engine.
  2. Place generator on a level surface.
  3. Turn main breaker switch Off.
  4. Turn fuel valve On.
  5. Switch engine control lever to Run.
  6. Press control panel engine Run/Stop switch to Run.
  7. Squeeze primer bulb 5-10 times until firm; fuel filter should show fuel level at least half full.
  8. Firmly grasp recoil handle, pull slowly until resistance is felt, flip red decompression lever, then pull rapidly up and away.
  9. Repeat until engine starts; if it does not start within 5 pulls, confirm steps 1-6 and repeat the primer step.
  10. Allow engine to run at least 10 seconds, then turn main breaker On.
  11. Select voltage rating with the voltage selector.

Full service-parts list: Generac XD5000E →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →