Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Untitled Procedure

Generac — Untitled Procedure

For these Generac models: NP, Q, Q70G.

Applies to: Generac Np, Generac Q

Before you start

  • NOTE: Standard AC voltmeters react to the AVER-
  • NOTE: When testing NP and Q-Serles generators,
  • NOTE: "NP" and "Q-Serles" Rotors are engine
  • NOTE: If the physical size of the conductor or

Procedure

  1. Always read the generator’s AC output voltage only at
  2. The generator’s voltage regulator can be adjusted for
  3. Only an AC voitmeter may be used to measure AC
  4. Always observe correct DC polarity.
  5. Before reading a DC voltage, always set the meter to
  6. The design of some meters Is based on the “current

Source: manual:Generac_IM-NP-Q.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.