Generac — Trigger Pickup Adjustment (iQ)
Adjustments
From a Generac service manual covering: Craftsman 2200i C0010020, Craftsman 3000i C0010030, GP2200, GP3000i, GP3500iO, IQ3500, PRO-3000i INV3000DMN, Premier 2200i INV2200DMN, iQ2000, iQ3500, iX 1600, iX 2000…. Check it applies to your exact model before use.
Applies to: Generac GP3000i, Generac GP3500iO, Generac IQ3500, Generac iX 1600, Generac iX 2000
Procedure
- Install or replace trigger pickup; ensure routing of wires is correct and not pinched.
- With rotor in place, set gap to 0.20-0.30mm using the oval holes in the pickup bracket.
- Align trigger point on rotor outside surface in-line with sensor and check/adjust gap with a non-metallic feeler gauge.
- Tighten mounting screws to specification and check gap; adjust if necessary.
Tools required
- non-metallic feeler gauge Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Trigger pickup gap: 0.20-0.30 mm
Full service-parts list: Generac GP3000i →, Generac GP3500iO →, Generac IQ3500 →, Generac iX 1600 →, Generac iX 2000 →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.