Generac — Transfer to Generator Power Source (Manual)
Operation · Transfer switch
From a Generac owner's manual covering: A2110, A4323, A6532, A6913, A9877, A9897, A9909, A9962, C1537, C1878, C2261, C2373…. Check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Do not activate the transfer switch manually until all power voltage supplies are positively turned off
Procedure
- Set generator Auto/Off/Manual switch to OFF.
- Set generator main circuit breaker to OFF (open).
- Turn OFF utility power supply to the transfer switch.
- Move manual transfer handle contacts to Standby position.
- Turn ON utility power supply to the transfer switch.
- Set Auto/Off/Manual switch to MANUAL to crank and start engine.
- Let engine stabilize and warm up for a few minutes.
- Set main circuit breaker to ON (closed); standby power now powers the loads.
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.