Generac — Testing the High Coolant Temperature Shutdown
Testing & diagnosis · High coolant temperature switch
From a Generac service manual covering: IM100G, IM80G, NP100G, NP80G. Check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Disconnect Wire No. 85 from the switch terminal.
- Start the engine, let it stabilize and warm up at no-load.
- Hold the terminal end of Wire No. 85 into contact with a clean frame ground on the engine.
- After a short delay, the engine should shut down.
Specs & values
- Switch contacts close and read continuity at about 225-235 F. (107-113 C.)
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.