Generac — Static Governor Adjustment
Adjustments
From a Generac service manual covering: 0D3358, 0D7675, 0D9033, 0D9708, 0E0038, 0E3342, EVT-04174-0, EVT-04198-0, EVT-04629-0, EVT-04629-1, EVT-04630-0, EVT-04712-0…. Check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Before starting or running engine, static adjustment of the governor must be completed; failure could result in engine overspeeding
Procedure
- Loosen the clinching screw on the governor lever
- Push on governor lever until throttle is wide open; do not bend governor link or distort governor lever
- Rotate governor arm clockwise as far as it will go and hold governor lever in WOT position
- While holding this position, torque the clinching screw to 11.3 Nm (100 in. lbs.)
- Check that throttle travels from WOT to IDLE; if not, reset the governor
Tools required
- Torque wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Clinching screw torque 11.3 Nm (100 in. lbs.)
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.