Generac — Starting Unit - Analog Controls
Operation · Control panel
From a Generac owner's manual — check it applies to your exact model before use.
Applies to: Mitsubishi L2E engine, Kubota Z482 engine
Before you start
- If unit does not start after 10 seconds of cranking, turn switch to STOP, wait 30 seconds, then repeat.
Procedure
- Open unit hood.
- Switch the flex switch (if equipped) to position 2.
- Close unit hood.
- Switch lights to OFF (O).
- Switch main AC circuit breaker to OFF (O).
- Turn ignition switch to GLOW PLUG position for 10 to 15 seconds.
- Turn ignition switch to START position and hold (10 seconds maximum) until engine starts.
- Release ignition switch; it moves to the RUN position.
Specs & values
- Do not hold ignition switch in GLOW PLUG position for more than 15 seconds.
- Do not crank engine for more than 10 seconds.
Full service-parts list: Kubota Z482 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.