Generac — Starting Electric Start Engines

Operation

From a Generac owner's manual — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

1. Unplug all electrical loads before starting
2. Ensure unit level (not exceeding 15° in any direction)
3. Open the fuel shut-off valve
4. Move choke knob outward to FULL CHOKE
5. Press and hold Start/Run/Stop switch to Start position
6. Release switch to run position once started
7. Move choke to 1/2-Choke then fully to Run position

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →