Generac — Servicing the Air Cleaner
Maintenance · Air filter
From a Generac owner's manual — check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Press the OFF button on the control panel to stop the generator.
- Lift the lid and remove the front panel.
- Remove the cover clips and air cleaner cover.
- Remove the old air filter element and discard it.
- Thoroughly clean the air cleaner enclosure of any dust or debris.
- Install a new air filter element.
- Install the air cleaner cover and fasten the cover clips.
- Verify that the air inlet duct is properly connected to the air cleaner cover.
- Press the AUTO button on the control panel to return to AUTO mode.
Tools required
- Screwdriver for cover clips Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.