Generac — Select Switch Removal (Wn)
Repair & overhaul
From a Generac service manual — check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Remove contactor assembly cover.
- Remove and label select switch wiring.
- Remove two screws holding select switch to inner side plate.
- For some smaller transfer switches, remove trip coil to access select switch screws (two access holes on outer left side plate).
- Reverse removal process for reinstallation.
Tools required
- screwdriver Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.