Generac — Rotor/Stator Removal (iX)
Repair & overhaul · Rotor and stator
From a Generac service manual covering: Craftsman 2200i C0010020, Craftsman 3000i C0010030, GP2200, GP3000i, GP3500iO, IQ3500, PRO-3000i INV3000DMN, Premier 2200i INV2200DMN, iQ2000, iQ3500, iX 1600, iX 2000…. Check it applies to your exact model before use.
Applies to: Generac GP3000i, Generac GP3500iO, Generac IQ3500, Generac iX 1600, Generac iX 2000
Procedure
- Remove 8mm bolt in center of recoil jaw.
- Remove two 8mm bolts from recoil jaw seat.
- Remove fan.
- Remove 15mm nut in center of rotor using a socket wrench with a steering wheel puller over it; counter the torque to break nut free.
- With nut removed, install steering puller tight against center shaft and remove rotor assembly.
- Remove two (2) 8mm bolts holding stator to engine casting.
- Remove stator.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Generac GP3000i →, Generac GP3500iO →, Generac IQ3500 →, Generac iX 1600 →, Generac iX 2000 →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.