Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Pump Rotating Assembly Removal

Generac MTP6000S3 — Pump Rotating Assembly Removal

For the Generac MTP6000S3.

Browse Generac generators & specs →

Before you start

  • Power source must be removed before starting.

Procedure

  1. The power source must be removed prior to removing the rotating assembly.
  2. Drain the oil in the seal cavity by removing the seal cavity drain plug.
  3. Clean and replace the drain plug after draining seal cavity of oil.
  4. Remove the four nuts on the studs of the volute and use the two jack screws to remove the rotating assembly from the volute.
  5. Separate the rotating assembly by pulling straight away from the pump casing.

Tools required

  • Jack screws

Source: manual:49519.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.