Generac RN100 — Manual Operation Normal Position
Operation · transfer mechanism
For the Generac RN100, from the Generac service manual.
Browse Generac generators & specs →
Before you start
- Do not use excessive force
- Do not operate under load
Procedure
- Observe window A position
- Attach handle to shaft if needed
- Move handle in arrow direction until stop
- Release handle slowly
- Verify window A ON and window B OFF
Tools required
- manual handle Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.