Generac — Remove Flywheel
Repair & overhaul
From a Generac service manual covering: EVT-04629-0, EVT-04629-1, EVT-04717-0, EVT-04797-0. Check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Flywheel puller bolts may damage lighting coil if turned in too far.
- DO NOT strike flywheel with a hard object or metal tool; it may shatter in operation.
Procedure
- Remove flywheel nut and washer.
- Remove fan retainer and fan.
- Reinstall flywheel nut flush with top of threads.
- Install flywheel puller.
- Tighten puller screws equally until flywheel loosens.
Tools required
- Flywheel puller Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.