Generac — Raising the Mast - Electric Winch (If Equipped)
Operation · Mast / electric winch
From a Generac owner's manual — check it applies to your exact model before use.
Applies to: Mitsubishi L2E engine, Kubota Z482 engine
Before you start
- Contact a GMASD immediately if the mast hangs up or the winch cable develops slack.
Procedure
- Set up and level the unit.
- Inspect mast cables for excessive wear or damage and verify they are centered in each pulley (A).
- Loosen mast rotation knob, turn mast to desired direction, tighten knob.
- Press and hold winch control switch (B) upward to telescope the mast.
- Stop extending when the colored mark (C) on the second mast section is visible.
Specs & values
- On key switch models, key must be in RUN position to operate electric winch.
Full service-parts list: Kubota Z482 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.