Generac QUIETPACT 75 — Remote Start/Stop Connections
Installation · Remote start/stop connector
For the Generac QUIETPACT 75, from the Generac owner's manual.
Applies to: Generac QuietPact 75, ISM 1.0L Diesel engine
Procedure
- If the six-wire remote connector is visible below the control panel, skip to step 5.
- Remove the electrical access panel located just below the knock-out labeled 'REMOTE'.
- Remove the 'REMOTE' knock-out, taking care not to damage the wiring behind it.
- Feed the remote connector through the hole and fit the supplied grommet into position.
- Wire the remote harness (Part # C6712C) to the vehicle's remote start panel.
- Plug the remote harness into the mating remote connector on the generator.
Tools required
- supplied grommet Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Remote harness Part # C6712C
Full service-parts list: Generac QuietPact 75 →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.