Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Post Installation Start-up and Adjustments

Generac — Post Installation Start-up and Adjustments

For these Generac models: EcoGen 6kW Generator, GT-530.

Applies to: Generac Ecogen 6Kw Generator, Generac Gt 530

Procedure

  1. 5.
  2. 6.
  3. 7.
  4. 8.
  5. 9.
  6. 10. Set the generator's AUTO/OFF/MANUAL switch to OFF. The
  7. 2.4
  8. 1.
  9. 2.
  10. 3.
  11. 4.
  12. 5.
  13. 6.
  14. 7.
  15. 8.
  16. 9.
  17. 10. Set the generator's main circuit breaker to its OFF (or OPEN)
  18. 11. Let the engine run at no-load for a few minutes.
  19. 12. Set the AUTO/OFF/MANUAL switch to OFF. The engine should
  20. 2.5

Source: manual:696471058185_use.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.