Generac — Place Trailer Tongue in Tow Position
Operation
From a Generac owner's manual — check it applies to your exact model before use.
Applies to: Mitsubishi L2E engine, Kubota Z482 engine
Before you start
- Pinching and crushing hazard. To avoid possible injury, keep fingers away from pivot point when folding or unfolding trailer tongue.
Procedure
- Verify unit is on a level surface and wheels are blocked.
- Remove clevis securing jack parallel to ground.
- Remove jack from tongue weldment; hold vertically and extend until weldment aligns with tongue weldment.
- Install jack and secure with clevis (D).
- Remove pins (B) and (C).
- Using both hands, slowly lower trailer tongue into tow position.
- Install pins as shown to secure trailer tongue in tow position.
Full service-parts list: Kubota Z482 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.