Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Place Trailer Tongue in Storage Position

Generac — Place Trailer Tongue in Storage Position

Operation

From a Generac owner's manual — check it applies to your exact model before use.

Applies to: Mitsubishi L2E engine, Kubota Z482 engine

Before you start

  • Pinching and crushing hazard. To avoid possible injury, keep fingers away from pivot point when folding or unfolding trailer tongue.

Procedure

  1. Verify unit is on a level surface and wheels are blocked.
  2. Extend jack (A) enough to allow minimum effort to pivot trailer tongue.
  3. Remove pins (B) and (C) from trailer tongue.
  4. Pivot trailer tongue into storage position.
  5. Install pins (B) and (C) at locations shown to secure tongue.
  6. Remove clevis and remove jack (A) from tongue weldment.
  7. Completely retract jack.
  8. Rotate jack 90° counterclockwise, place on weldment, install clevis.

Full service-parts list: Kubota Z482 engine →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →