Generac — Open Enclosure
Maintenance · Transfer switch enclosure
From a Generac service manual covering: RXSC100A3, RXSC200A3, RXSW100A3, RXSW150A3, RXSW200A3. Check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Inner Panel only available in models that are Service Entrance Rated.
Procedure
- Remove thumb screw (B).
- Slide slot (C) over retention tab.
- Lower cover until clear of top flange (D), and pull away from enclosure.
- Loosen nut (F) until it clears t-slot (H) in inner panel.
- Grasp inner panel at two cutouts (G) and tilt panel, passing nut through t-slot.
- Lower inner panel until clear of two retention slots (J), and pull away from enclosure.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.