Generac MLT3060K / MLT3060M — Towing the Unit

Operation · Trailer and hitch

For the Generac MLT3060K / MLT3060M, from the Generac owner's manual.

Applies to: Generac MLT3060K, Generac MLT3060M, Mitsubishi L3E-W461ML engine, Kubota D1005-E3BG1-MGM-1 engine

Procedure

1. Engine shut down, mast and lights properly stowed
2. Raise rear jack completely and release locking pin to rotate into travel position
3. Verify locking pins snap into place
4. Raise outrigger jacks completely and release jack locking pins to swing into travel position
5. Release outrigger locking pins and slide outriggers into trailer frame until locking pins snap
6. Use tongue jack to raise or lower trailer onto hitch of towing vehicle
7. Lock hitch coupling and attach safety chains to vehicle
8. Remove jack locking pin and rotate jack into travel position, replace pin
9. Apply grease to coupler if needed
10. Lubricate grease fittings on leveling jacks per Jack Maintenance procedures
11. Connect trailer wiring to tow vehicle
12. Check for proper operation of directional and brake lights
13. Verify mast cradle locking pin is in place
14. Verify doors and enclosure are properly latched
15. Remove bulbs from light fixtures if driving over rough ground

Full service-parts list: Generac MLT3060K →, Generac MLT3060M →, Kubota D1005-E3BG1-MGM-1 engine →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →