Generac MLT3060K / MLT3060M — Raising the Mast
Operation · Mast and lights
For the Generac MLT3060K / MLT3060M, from the Generac owner's manual.
Applies to: Generac MLT3060K, Generac MLT3060M, Mitsubishi L3E-W461ML engine, Kubota D1005-E3BG1-MGM-1 engine
Before you start
- Contact service dealer if mast hangs up or cable develops slack
- Do not extend mast beyond colored mark
- Keep area around unit clear of people
Procedure
- Set up and level the unit
- Check both sets of mast cables for excessive wear or damage
- Verify cables are properly centered in each pulley
- Check electrical cord for damage
- Press and hold winch control toggle switch upward to telescope mast to desired height
- Extend mast slowly, verify coiled electrical cord is extending at top sections
- Do not extend past the colored mark on the mast section
- Loosen mast rotation knob to rotate mast
- Turn mast until lights face desired direction and tighten knob
Specs & values
- Maximum mast height: 25 ft (7.6 m)
- Do not extend past colored mark on second mast section
Full service-parts list: Generac MLT3060K →, Generac MLT3060M →, Kubota D1005-E3BG1-MGM-1 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.