Generac MLT3060K / MLT3060M — Manual Mast Lowering
Repair & overhaul · Winch assembly
For the Generac MLT3060K / MLT3060M, from the Generac owner's manual.
Applies to: Generac MLT3060K, Generac MLT3060M, Mitsubishi L3E-W461ML engine, Kubota D1005-E3BG1-MGM-1 engine
Before you start
- Use only if absolutely necessary
- Continuous use could damage planetary gear brake
- Procedure will not work if planetary gear brake is damaged
Procedure
- Remove power cables from two terminals on winch motor assembly
- Remove two flange head screws securing winch motor assembly to winch
- Carefully remove motor assembly, ensuring two pieces do not separate
- Insert 3/8 inch allen head wrench into sleeve bearing
- Rotate wrench counterclockwise to lower mast
- Stop immediately if any slack is observed in cable and remove the slack
- When mast is completely down, install winch motor assembly and secure with screws
Tools required
- 3/8 inch allen head wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Generac MLT3060K →, Generac MLT3060M →, Kubota D1005-E3BG1-MGM-1 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.