Generac MLT3060K / MLT3060M — Lowering the Mast
Operation · Mast system
For the Generac MLT3060K / MLT3060M, from the Generac owner's manual.
Applies to: Generac MLT3060K, Generac MLT3060M, Mitsubishi L3E-W461ML engine, Kubota D1005-E3BG1-MGM-1 engine
Before you start
- Lamps become extremely hot during use; allow 10-15 minutes for cooling before handling
- Contact service dealer if mast hangs up or cable develops slack
- Do not raise or lower mast while unit is operating
Procedure
- Shut down lights and engine
- Optionally rotate mast so lights face toward back of unit for transport
- Loosen mast rotation knob to rotate mast
- Rotate mast until white arrows are aligned and metal stop tabs are touching
- Tighten mast rotation knob
- Press and hold winch control toggle switch downward to collapse mast to lowest position
- Verify electrical cord does not get caught or pinched during lowering
Full service-parts list: Generac MLT3060K →, Generac MLT3060M →, Kubota D1005-E3BG1-MGM-1 engine →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.