Generac — Manual Operation - Close to Emergency Source Side
Operation · Transfer switch mechanism
From a Generac service manual — check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Do not use excessive force when operating the transfer switch manually or the manual handle could be damaged.
Procedure
- Verify position by observing window B in Figure 3.1. If window B reads ON, no further action required.
- Attach handle to actuating shaft.
- Move handle in direction of arrow on switch cover until it stops. Do not force.
- Release handle slowly to allow spring in switch box to relax.
- OFF now appears in Window A and ON appears in Window B.
Tools required
- Manual handle Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.