Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Jack Maintenance

Generac — Jack Maintenance

Maintenance · Jacks

From a Generac owner's manual covering: MLT3060K, MLT3060M, MLT3080KV. Check it applies to your exact model before use.

Applies to: Generac MLT Light Tower, Generac MLT3060K, Generac MLT3060M, Mitsubishi L3E-W461ML engine

Procedure

  1. For side-wind models, keep internal gearing and bushings lubricated.
  2. Apply small amount of automotive grease to internal gearing by removing jack cover or use needle nose applicator/grease gun on lubrication point.
  3. Rotate jack handle to distribute grease evenly.
  4. Apply lightweight oil to handle unit at both sides of tube for side-wind models.
  5. If equipped, lubricate axle bolt and nut assembly of caster wheel with same lightweight oil.
  6. For top-wind models, apply lightweight oil to screw stem.

Tools required

Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.

Specs & values

  • Perform at least annually.

Full service-parts list: Generac MLT Light Tower →, Generac MLT3060K →, Generac MLT3060M →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →