Generac — Installing Wall Bracket
Installation
From a Generac service manual covering: PWRcell M3, PWRcell M3 DCB, PWRcell M4, PWRcell M4 DCB, PWRcell M5, PWRcell M5 DCB, PWRcell M6, PWRcell M6 DCB. Check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Project a vertical line up from the top mounting fastener in the foot bracket.
- Place a mark 30 11/16 in (779.2 mm) above the top mounting fastener of the foot bracket.
- Insert first fastener in the lower hole of the wall bracket at the mark; leave partially loose.
- Level wall bracket and double check alignment.
- Install and tighten both lower wall bracket mounts.
- Double check wall bracket fasteners align with foot bracket fasteners and bracket is plumb.
- Install a minimum of two fasteners in the top holes of the wall bracket.
Tools required
- Level Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Bottom edge (A) is 29-5/8 in (752 mm) off the floor for installations that are not elevated
- 16 in (40.64 cm) on center studs
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.