Generac — Installing Retention Clips
Installation
From a Generac service manual covering: PWRcell M3, PWRcell M3 DCB, PWRcell M4, PWRcell M4 DCB, PWRcell M5, PWRcell M5 DCB, PWRcell M6, PWRcell M6 DCB. Check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Align holes in retention clip (V) with stud (W) and mounting hole (X).
- Apply gentle pressure to ensure all grounding tabs and clips make firm contact with case.
- Secure retention clip to bracket with a M4X8 mm screw and torque to 13 in-lb (1.47 Nm).
- Install single retention clips at the top and bottom of the stack.
- Install double retention clips between rows of modules.
Specs & values
- 13 in-lb (1.47 Nm)
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.