Generac — Installing Module Spacer (PWRcell M3 and PWRcell M5 only)
Installation
From a Generac service manual covering: PWRcell M3, PWRcell M3 DCB, PWRcell M4, PWRcell M4 DCB, PWRcell M5, PWRcell M5 DCB, PWRcell M6, PWRcell M6 DCB. Check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Kits must be installed by a qualified individual.
Procedure
- Angle top of spacer (P) under and behind bracket lip (Q).
- Slide spacer up between brackets.
- Push bottom of spacer in.
- Secure spacer with two M4X8 SEMS screws and torque to 13 in-lb (1.47 Nm).
Specs & values
- 13 in-lb (1.47 Nm)
- Module Spacer Kit part number APKE00008 Amazon eBay $15.95
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.