Generac — Installing Grounding Tabs
Installation
From a Generac service manual covering: PWRcell M3, PWRcell M3 DCB, PWRcell M4, PWRcell M4 DCB, PWRcell M5, PWRcell M5 DCB, PWRcell M6, PWRcell M6 DCB. Check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Install two L-shaped grounding tabs (L) at the bottom of the module on both sides.
- Fasten each grounding tab with a M4x8 mm SEMS screw (M), torque to 13 in-lb (1.47 Nm).
- Install grounding tabs (L) at the top of the module on both sides.
- Fasten each grounding tab with a M4x8 mm SEMS screw (M), torque to 13 in-lb (1.47 Nm).
Specs & values
- 13 in-lb (1.47 Nm)
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.