Generac — Installing Foot Bracket
Installation
From a Generac service manual covering: PWRcell M3, PWRcell M3 DCB, PWRcell M4, PWRcell M4 DCB, PWRcell M5, PWRcell M5 DCB, PWRcell M6, PWRcell M6 DCB. Check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Install foot bracket bottom edge along bottom of wall no higher than 5 in (12.7 cm) above grade.
- Locate structural members to mount foot bracket; install cross brace if members are greater than 16 in (40.64 cm) apart.
- Install foot bracket using lower holes with fasteners and washers; keep bracket plumb and level.
- Slide foot stands onto foot bracket, making sure underside of pockets clear bottom bracket before engagement.
- Use flat washers and fasteners to secure top of foot bracket and stands.
Tools required
- Stud finder Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 5 in Max (12.7 cm) above grade
- Middle of Battery Disconnect Switch maximum 79 in (200.66 cm) above grade
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.