Generac — Installing Ethernet Cable
Installation
From a Generac manual — check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Keep Ethernet cable away from high voltage connections
Procedure
- Run Ethernet cable through knockout in kick plate or pull through generator installation pad
- Pull cable through hole in support rail or through cutout in stub-up area
- Route cable upward to plug into device
- Use tie wraps to secure Ethernet cable away from high voltage wires or connections
Source: Generac manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.