Generac — Installing Cover
Installation · Front cover
From a Generac service manual covering: PWRcell M3, PWRcell M3 DCB, PWRcell M4, PWRcell M4 DCB, PWRcell M5, PWRcell M5 DCB, PWRcell M6, PWRcell M6 DCB. Check it applies to your exact model before use.
Browse Generac generators & specs →
Before you start
- Do not force cover into place.
Procedure
- Place cover (A) upright in front of unit.
- Verify all cables are tucked in and clear of frame.
- Slide cover straight back until it engages with body (B).
- Verify all angled guides are tucked inside body and back edges are against the gasket.
- Lift straight up; pins on cover will engage and hold the top in place.
- Gently push in on the bottom of the cover to lock it in place.
- Install two M4X16 mm screws (D) and torque to 13 in-lb (1.47 Nm).
Specs & values
- 13 in-lb (1.47 Nm)
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.