Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Stopping the Generator

Generac HomeLink 6500 Series — Stopping the Generator

Operation

For the Generac HomeLink 6500 Series, from the Generac owner's manual.

Applies to: Generac HomeLink 6500 Series

Before you start

  • NEVER start or stop the engine with electrical devices plugged in and turned on.

Procedure

  1. Shut off all loads, then unplug the electrical loads from the panel receptacles or extension cord.
  2. Let the engine run at no-load for several minutes to stabilize internal temperatures.
  3. Move the off/run/start switch to the OFF position.
  4. Close the fuel valve.

Full service-parts list: Generac HomeLink 6500 Series →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →