Generac HomeLink 6500 Series — Battery Replacement
Maintenance
For the Generac HomeLink 6500 Series, from the Generac owner's manual.
Applies to: Generac HomeLink 6500 Series
Procedure
- Disconnect and remove the battery mounting hardware (8mm) and BLACK wire from the NEGATIVE (-) terminal.
- Move the red protective boot and disconnect the mounting hardware (8mm) and RED wire from the POSITIVE (+) terminal.
- Remove the two screws and bracket from the battery tray. Remove the battery.
- Place the new battery in the tray. Secure with the bracket and two mounting screws.
- Reconnect the RED wire to the POSITIVE (+) terminal and the BLACK wire to the NEGATIVE (-) terminal.
Tools required
- 8 mm wrenches Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- NEGATIVE (black) (-) cable should always be DISCONNECTED FIRST and CONNECTED LAST
Full service-parts list: Generac HomeLink 6500 Series →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.