Generac GN-724 / GN724 — Static Governor Adjustment
Adjustments
For the Generac GN-724 / GN724, from the Generac service manual.
Browse Generac generators & specs →
Before you start
- BEFORE STARTING or running engine, static adjustment of the governor must be completed. Failure could result in engine overspeeding.
Procedure
- Loosen governor clamp bolt.
- Push spring end of governor lever clockwise to wide open throttle.
- Rotate governor shaft fully clockwise with screwdriver.
- Hold both and tighten clamp bolt to 70 inch-pounds (8 N-m).
- Start engine, warm up, adjust speed nut to 62 Hertz at no-load.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 70 inch-pounds (8 N-m)
- 62 Hertz at no-load
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.