Generac GN-724 / GN724 — Change Engine Oil Filter

Maintenance · Lubrication system

For the Generac GN-724 / GN724, from the Generac service manual.

Browse Generac generators & specs →

Procedure

1. With oil drained, remove old oil filter by turning counterclockwise.
2. Apply light coating of clean engine oil to gasket of new filter.
3. Screw new filter on by hand until gasket lightly contacts adapter.
4. Tighten filter an additional 3/4 to one turn.
5. Refill with proper oil; start engine and check for leaks.

Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →