Generac GN-724 / GN724 — Change Engine Oil
Maintenance · Lubrication system
For the Generac GN-724 / GN724, from the Generac service manual.
Browse Generac generators & specs →
Before you start
- Never operate engine with oil level below the "Add" mark on dipstick.
Procedure
- Run engine until warm, then shut OFF.
- Pull oil drain hose free of retaining clip; remove cap and drain oil.
- Replace cap and retain hose in clip.
- Refill with recommended oil.
Tools required
- Suitable container Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil capacity approximately 2 quarts
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.