Generac GN-724 / GN724 — Assemble Oil Pump
Repair & overhaul · Lubrication system
For the Generac GN-724 / GN724, from the Generac service manual.
Browse Generac generators & specs →
Procedure
- Lubricate oil pump components with engine oil.
- Install drive shaft, inner rotor, outer rotor.
- Install new O-ring and oil pump cover.
- Torque screws to 50 in. lbs. (5.6 Nm).
Tools required
- Torque wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 50 in. lbs. (5.6 Nm)
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.