Generac — Generator Location
Installation
From a Generac service manual — check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Install generator set, in its protective enclosure, outdoors where adequate cooling and ventilating air is always available.
- Install the unit where air inlet and outlet openings will not become obstructed by leaves, grass, snow, etc.
- Install the generator on high ground where water levels will not rise and endanger it.
- This genset must be installed on a level surface. The base frame must be level within 1/2 inch all around.
- Allow sufficient room on all sides of the generator for maintenance and servicing.
- Where strong prevailing winds blow from one direction, face the generator air inlet openings into the prevailing winds.
- Install the generator as close as possible to the transfer switch. This reduces the length of wiring and conduit.
- Install the generator as close as possible to the fuel supply, to reduce the length of piping.
Specs & values
- Base frame must be level within 1/2 inch all around.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.