Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›TRANSFER BACK TO UTILITY POWER SOURCE

Generac — TRANSFER BACK TO UTILITY POWER SOURCE

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

  1. Set the generator’s main circuit breaker to its OFF (or OPEN)
  2. Let the engine run for a minute or two at no-load to stabilize
  3. Set the generator’s AUTO/OFF/MANUAL switch to its OFF (or
  4. Check that utility power supply to the transfer switch is turned
  5. Use the manual transfer handle inside the transfer switch to
  6. Turn ON the utility power supply to the transfer switch using

Source: manual:0H8358.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.