Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Testing the Fuel Lockoff Solenoid

Generac — Testing the Fuel Lockoff Solenoid

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Before you start

  • Do not attempt to adjust the gas regulator without proper training.

Procedure

  1. Set a volt-ohm-milliammeter (VOM) to read battery voltage.
  2. Check voltage at the fuel solenoid.
  3. Verify proper operation using test equipment.

Tools required

  • Volt-ohm-milliammeter (VOM)

Source: manual:94468A.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.