Generac — Fuel Conversion (NG to LP)
Installation · Fuel System
From a Generac service manual — check it applies to your exact model before use.
Browse Generac generators & specs →
Procedure
- Remove four 6mm Allen head fasteners, lift top lid
- Remove two 4mm Allen head fasteners, lift rear panel
- Squeeze hose clamp, slide from fuel inlet fitting
- Remove hose from fuel inlet
- Remove NG fuel jet from fuel inlet
- Insert propane fuel jet into fuel inlet
- Reinstall hose onto fuel inlet, secure with clamp
- Verify hose not kinked
- Reinstall rear access panel, secure with 2 shorter Allen screws
- Reinstall top lid with 4 long Allen screws
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.