Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Water Testing New Engines

Generac — Water Testing New Engines

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Before you start

  • Do not run at maximum rpm for more than 2 minutes.

Procedure

  1. Start engine and run at idle rpm until normal operating temperature is reached.
  2. Run boat up on plane.
  3. Advance engine rpm (in 200 rpm increments) until engine reaches its maximum rated rpm.
  4. NOTE: Do not run at maximum rpm for more than 2 minutes.

Source: manual:SM--MERCURY MERCRUISER MARINE ENGINES GM V6 262 CID (4.3L) 1998 Service Repair Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.