Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Note: Refer to Figure 4 in Section 1.3 for illustra­

Generac — Note: Refer to Figure 4 in Section 1.3 for illustra­

For these Generac models: 389/206/163cc, 410cc, GP1800, GP3250, GP5000, GP5500, GP6500, GP7000, GP8000.

Applies to: Generac Gp1800, Generac Gp3250, Generac Gp5000, Generac Gp5500, Generac Gp6500, Generac Gp7000, Generac Gp8000

Procedure

  1. Disconnect Wires 11, 22, 33, 44 from the receptacle
  2. Make sure all of the disconnected leads are isolated
  3. Set a VOM to measure resistance.
  4. Connect one test lead to Stator Lead 11. Connect the
  5. Connect one test lead to Stator Lead 33. Connect the
  6. Make sure all leads are isolated from each other and are
  7. Connect one test lead to a clean frame ground. Connect
  8. Repeat Step 2 using Stator Lead 44
  9. Connect one test lead to Stator Lead 11. Connect the

Source: manual:GP Series Service Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.