Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›SHAFT:

Generac — SHAFT:

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Procedure

  1. 1. Assemble governor shaft to sump to act as a pilot for bush-
  2. ing.
  3. Do not install lower E-ring.
  4. 2. Using Briggs & Stratton Tool P/N 19129, press in bushing until
  5. it bottoms, Fig. 13.
  6. 3. Install lower E-ring.
  7. a. Install new oil seal.
  8. Governor shaft must rotate freely.

Source: manual:0C8221.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.