Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›DISASSEMBLE:

Generac — DISASSEMBLE:

A Generac service procedure — check it applies to your exact model before use.

Browse Generac generators & specs →

Before you start

  • Note: Intake push rods are aluminum.

Procedure

  1. 1. Loosen governor lever nut.
  2. a. Remove governor lever from shaft, Fig. 6.

Specs & torque values

  • to readjust valve clearances.

Source: manual:0C8221.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.